PLEASE NOTE!

Product description has been updated to match my updated design, however the stock photos show the old version. Very little visual differences between the two but please read all the info below for fitment and description.

-Made from 3/8” thick and 1/4” 304 SS plate.

-High polish, Mirror finish to blend in with your chrome case covers. *ONLY THE FRONT, SIDES AND EDGES ARE POLISHED.

-Fits 86- 03 HD rigid mount sportsters

-Use these plates with your Oem mid controls to raise up your foot position 1.5” and also pushes your brake forward 1” to be even with the shift side.

(If you look at your controls from above before removing, they are not even close to even with each other..)

-These will be more comfortable then your OEM mids and the lift provides more room for custom exhaust that doesn’t look dreadful hanging below your frame.

-For use with OEM mid controls, if using after market mid controls you may need to make modifications.

INCLUSIONS:

-Shift side lift plate

-Shift side mounting hardware (The long case bolts get reused)

-Brake side lift plate

-Hardware for mounting plate and master cylinder to new lift bracket

-New zinc plated bolt on clevis with hardware

-All Stainless steel hardware to install.

FITMENT NOTES:

Some shimming may be required. In my experience installing some sprocket covers sit in too far and the very top screw on the right requires a thin shim washer to bring it out flush with the other cover. 

Take care when tightening the 3 small cover screws, it is your responsibility to correct fitment before tightening.